Skip to content
cropped-logo-200.webp
GemTech PCB
  • About Us
  • PCB Products
    • HDI PCB
    • RF & Microwave PCB
  • Manufacturing
  • Blog
  • About Us
  • PCB Products
    • HDI PCB
    • RF & Microwave PCB
  • Manufacturing
  • Blog

Category: Uncategorized

Via-in-Pad and VIPPO: When a Via in a Pad Needs Filling and Copper Capping

Via-in-pad PCB guide cover showing vias inside and outside component pads.

Learn when via in pad needs a filled and copper-capped surface, how open holes can affect solderable pads, and when a dogbone via can stay outside the pad.

PCB Via Fill: What Resin, Copper, and Capping Each Change

PCB via fill guide cover showing resin fill, copper fill, and a copper cap.

Compare resin and copper via fill, caps, and solder mask coverage. Learn what each changes inside a plated via and what to specify before fabrication.

HDI PCB Guide: Microvias, Stackups, and Manufacturing Choices

Six-layer HDI PCB cross-section with a blind microvia and a plated through-hole

Understand HDI PCB structures, microvias and sequential lamination. Compare routing options, manufacturing tradeoffs and the files needed for review.

Blind Via PCB: Layer Spans, Buried Vias, and Process Choices

Editorial cover for the B2 blind and buried via article, with a conceptual layer-span diagram.

Compare blind via PCB and buried via structures by layer span and process order. Confirm the stackup, hole size and drill pair details before fabrication.

PCB Microvias: How to Compare Landing Interfaces, Stacked and Staggered Structures

Editorial cover for the B3 microvia article with conceptual single, stacked, and staggered structures.

Compare PCB microvias by layer span, target copper, stacked or staggered placement, and the drawing details a fabricator needs to review each connection.

PCB Surface Finish: Solder Pads and Contact Areas

Green printed circuit board with exposed component pads and gold-colored edge contacts.

Choose a PCB surface finish by separating solder pads from edge contacts, then compare each finish against assembly, storage, and connector requirements.

Standard PCB Thickness: Finished Thickness, Tolerance, and Mechanical Fit

PCB panels viewed from the side, showing copper-colored edges and visible dielectric layers.

Learn how to choose PCB thickness for mechanical fit, define finished thickness and tolerance, set a measurement basis, and review how stackup changes affect hole aspect ratio and controlled impedance.

PCB DFM review before manufacturing: files, dimensions, and engineering approval

A row of mechanical PCB drilling equipment in a board-processing area.

This PCB DFM checklist shows how to align design and manufacturing files, check dimensions and process conditions, resolve engineering questions, and release one approved manufacturing package.

Multilayer PCB Manufacturing Process: From Inner-Layer Imaging to Bare-Board Inspection

Automatic pattern-plating equipment behind a safety rail, with visible signs.

Follow a common mechanically drilled multilayer bare-board route from imaging and lamination through plating, solder mask, and inspection. Steps vary by stack-up, hole types, and surface finish.

Next →
logo-original
GemTech PCB

Printed circuit boards for your next design. Discuss your manufacturing requirements with our team.

Company

About us

Manufacturing

Quality

Project workflow

PCB products

Multilayer PCB

HDI PCB

RF & Microwave PCB

High-speed PCB

Heavy Copper PCB

Resources & contact

Materials & production

Applications

Enquiry checklist

Request a quote

© 2026 GemTech PCB. Homepage design preview.

Back to top ↑